CABASSE ALTURA Manual - page 14
e
n
g
l
i
s
h
Interconnections with the Cinch RCA LINE IN
8
and LINE OUT
9
connectors
■
Connections to the LINE IN
8
If your preamplifier or your integrated amplifier is fitted with
a stereo low-level output, then connect its L (left) and R (right)
outputs to the L (left) and R (right) LINE IN
0
inputs of the sub-
woofer. If your amplifier offers a one mono output, connect it
to either the L (left) or the R (right) subwoofer LINE IN
0
inputs.
■
Connections from the LINE OUT
9
The signal from the L (left) and R (right) LINE OUT
9
connec-
tors is the one being brought in by the L (left) and R (right) LINE
IN
8
connectors filtered at 40 Hz. These outputs can thus
be used to bring the signal to the amplifier powering the main
loudspeaker.
Interconnections with the speaker terminals
■
Connections to HIGH LEVEL INPUT
0
plugs
If the preamp section of your Hi Fi or audio-video system is not
fitted with a low level output, you should then connect the
subwoofer by using its loudspeaker terminals. When connec-
ting the L (left) and R (right) speaker outputs of your amplifier
to the HIGH LEVEL INPUT
0
plugs of the subwoofer, be care-
ful not to cross (-) and (+) cord of either L (left) or R (right)
channel. Such a phase inversion might damage your main
amplifier.
■
Connections HIGH LEVEL OUTPUT
-
plugs
These outputs can be used to bring the signal to the main
loudspeaker systems.
The signal from the L (left) and R (right) HIGH LEVEL OUT-
PUT
-
plugs is the one being brought in by the HIGH LEVEL
INPUT
0
connectors. These outputs can thus be used to bring
the signal to the main loudspeaker systems.
Power supply
The AC in
=
cord must be connected to the mains to supply
the subwoofer. The selection of the right voltage 115 V - 230 V
is done with 115 V - 230 V
q
. Switch POWER
w
, on STAND BY
or ON. With the switch on the STAND BY position, the unit will
mute after a few minutes without input signal. The system
turns on automatically when signal comes back.
Adjustments
■
LEVEL
e
For a first volume adjustment, position the CROSSOVER
FREQUENCY
r
at around 120 Hz, and turn slowly the LEVEL
e
clockwise from minimum level up to a position where you feel that
the subwoofer sound level is appropriate. A check of the level
adjustment will be necessary after following steps.
Position
Ways
Drivers complement
Altura RIVA
bookshelf 2
DOM50-17M18LB2
main speaker / surround
/stand
Altura BAHIA
floorstanding
3
DOM50
-
13M15M2
main speaker
2
x
17M18LB2
Altura LARGO
floorstanding
1
30M40
active subwoofer
Altura SENA
on / under
2
DOM50
center
TV
2
x
13M15M2TV
Altura LINEA
floorstanding
2.5
DOM50
floorstanding
2
x
13MTR5
Altura LINEA
bookshelf 2.5
DOM50
on base
/ on wall
2
x
13MTR5TV
Cab notice Altura gamme 2005-4 28/10/05 9:59 Page 14