Cabletron Systems Cabletron SmartSwitch Router 510 Installation And Configuration Manual - page 62

Configuring the Router

 4-16

[2] Set In-Band Interface IP Address

This option prompts you to change or enter the IP address and subnet mask 

for the in-band interface. You can only configure one in-band interface at a 

time. The router does not need to be configured with a subnet mask for SNMP 

communications when management stations are on the same subnet as the 

router.

The format for these values is the standard 4-octet dotted decimal notation, in 

which each octet of the address is represented as a decimal value, separated by 

a decimal point (.). 

The following example shows the dialog associated with this selection.

Enter selection   2

SmrtSwtch Rtr 5xx 

=========================================================

IN-BAND INTERFACE IP ADDRESS CONFIGURATION

                 example: 134.12.13.14

       To delete the IP address, enter 0 in the appropriate

================================================================

Enter the IP address [] : 134.12.13.14

Enter the Subnet Mask [0.0.0.0] : 255.255.0 0 : 

              Press Return for IP Configuration Menu ...

Interface        IP Address     Subnet Mask     Other Info

Ethernet

Format:  The standard 4 octet dotted decimal notation in which

        each octet of the address is represented as a decimal 

        value, separated by a "." character.

        address field.

======