Cabletron Systems Cabletron SmartSwitch Router 510 Installation And Configuration Manual - [5] Go To Local Console

Configuring the Router

4-19

[5] Go To Local Console

This selection runs quick configuration. If you reset to factory defaults and 

select 

Go to Local Console

 without having configured the router via 

the installation menu, the qconfig process starts automatically.

After making the changes you want, exit quick configuration and apply the 

changes you made by typing restart. The system displays the following 

messages:

If you type restart at the 

Config (only)>

 prompt, the following message 

displays:

Enter yes to proceed. The following menu is then displayed. 

Quick Config Done

Type RESTART at Config (only)> prompt for the configuration to

take effect.

Config (only) >

Config (only)>restart 

Are you sure you want to restart the gateway? (Yes [No]):

SmrtSwtch Rtr 5xx

==================================================================

        SmrtSwtch Rtr 5xx INSTALLATION MENU

    **************************************************

     To fully manage this device telnet to one of the

    following IP addresses or select item [3] below.

              Out-of-Band: Not Configured

              In-Band    : 134.1.147.150

    **************************************************

           [1] Restart with Factory Defaults

           [2] Restart with Current Settings

           [3] Go to Local Console

==================================================================

              Enter selection :