Cabletron Systems CyberSWITCH CSX500 Setup Manual

PN 9032534-03

Page 1 of 2

CSX500 SETUP GUIDE

PRE-CONFIGURATION INFORMATION

This Setup Guide describes the tools needed to configure the CyberSWITCH CSX500.

Figure 1

 shows the CyberSWITCH CSX500.

Figure 1 The CSX500 

QuickSet CONFIGURATION SETUP

Tools needed

The following tools are required to configure the CSX500:

•

Personal Computer (PC)

•

Read Me First!

 instruction sheet (enclosed in the manual package)

•

QuickSet CD (located in the shipping box with your device)

Only qualified personnel should install the CSX500. This Setup Guide is intended for the experienced 

network equipment installer.

NOTE

For further details concerning the operation of the CSX500, refer to the HSIM-W84 documentation on 

the QuickSet CD. The HSIM-W84 is similar to the CSX500. The difference is that the HSIM-W84 is a 

module that is installed into a host device, while the CSX500 is a standalone unit. All other information 

pertaining to the device is the same. 

NOTE

Cabletron Systems highly recommends using the QuickSet utility to configure the CSX500. Using the 

QuickSet CD will ensure a fast and correct installation. Using other methods may not produce correct or 

as efficient results as the QuickSet CD. 

STS

LNK

STS

LNK

STS

LNK

STS

LNK

STS

LNK

TX

RX

TELCO

T1-1

T1-2

T1-3

T1-4

ASYNC

CONSOLE

CPU

PWR

ROUTER/SWITCH/INVERSE MUX

LAN

ENET

WAN BRANCH OFFICE CONCENTRATOR