Cabletron Systems MMAC-M3FNB Overview And Setup Manual - page 10
INTRODUCTION
Page 1-2
1.1.1
Symbols
Throughout this manual you will see two symbols which will be used
to call your attention to important safety-related information:
You will also see a third symbol, which will be used to call your
attention to additional information not related to safety:
1.2
USING THE MMAC-M3FNB MANUAL SET
Other manuals have been developed for the Repeater/Management
modules and for each MIM that can be installed in your
MMAC-M3FNB. These manuals explain how to install the individual
modules into the MMAC-M3FNB, how to attach segments to the
modules, and how to test those segments after they have been
installed.
Additional manuals have been developed on how to use Cabletron’s
SPECTRUM for Open Systems suite of network management
products.
Each manual in this set assumes that you have a general working
knowledge of Ethernet or IEEE 802.3, 802.5, and FDDI type data
communications networks and their physical layer components.
CAUTION: when you see this symbol, you will be
provided with special precautionary information that
can help you guard against improper use of your
equipment.
WARNING: when you see this symbol, note that failure
to follow the instructions provided can result in an
electrical safety hazard.
NOTE: the information that follows could help you to
better use and understand your equipment.
NOTE