CableTronix CT-SAW860 Installation Manual - page 3
SPECIFICATIONS
CT-SAW860
SAW-Filtered Audio/Video Modulator Specifications (Typical)
RF
1.Output Channels
TV VHF: 2-13, UHF: 14-69, CATV: 2-127
2.Output Level
+55 dBmV (minimum)
.Output Level Range
13 dB
4.A/V Carrier Ratio
-7dB to -22dB
5.Spurious Output
-60 dB below video carrier (@A/V carrier ration -15 dB)
6.Frequency Accuracy/Stability
±5 KHz
7.Output Impedance
75 Ohms
8.Output Return Loss
9 dB
VIDEO
1.Video Input Level
0.5 Vp-p minimum @87.5% Modulation
2.Differential Gain
<5% (10 to 90% APL)
3.Differential Phase
<5˚ (10 to 90% APL)
4.Hum and Noise
-60 dB @87.5% Modulation
5.Visual Carrier to Noise Ratio
60 dB @4 MHz BW
6.Frequency Response
±0.8 dB (30 Hz to 4.2 MHz)
AUDIO
1.Input Level
0.5 Vp-p for ±25 KHz Deviation
2.Input Impedance
600 Ohms Unbalanced
3.Pre-Emphasis
75 µSec
GENERAL
1.Power Input Range
120 VAC, 60 Hz
2.Operating Temperature
32 ˚F ~ 122 ˚F
3.Connectors
All "F" Type
MECHANICAL
1.Dimensions
19" (W) x 1.75" (H) x 2.25" (D)
2.Weight
4.3 lbs
INSTALLATION AND OPERATION
NOTE TO SYSTEM INSTALLER
System installer must adhere to Article 820-40 of the NEC that
provides guidelines for proper grounding and specifies that the
cable ground shall be connected to the grounding system of the
building, as close to the point of cable entry as practical.
3