CAD Audio CADLive WX3000 Manual And Quick Start-up Manual - page 4
2
11
Startup Guide
1. Install new high quality alkaline batteries into transmitter,
observing proper polarity.
2. Power up receiver by holding power button for one second.
3. Hold the SET button for one second to unlock the
receiver menu.
4. Hold the SCAN button for one second to activate the ScanLink
TM
environmental frequency analysis, which automatically selects
a clear operating frequency.
5. Turn on the transmitter by holding the power button
for one second.
6. Open the battery compartment to reveal the IR node.
7. Press the LINK button (note the IR node will illuminate). Align
the two IR nodes (transmitter and receiver) at a distance of
4"-12" (ambient room light can affect distance) for a few
seconds while the receiver updates the transmitter.
Your system is now ScanLink'd.
• Simultaneous usage of up to 15 systems per frequency band
• Dynamic Range > 110dB
• AA Batteries with up to 15 Hrs of battery life
• Systems ship with rack ears single/dual BNC relocation kit and
durable carry case
• BodyPack systems include miniature E19 Earworn, E29 Lav,
WXGTR guitar cable
• XLR and ¼" outputs on receiver
Interfacing to CADTone TB4M-type input connector
3k3
10k
3k3
3k3
3k3
3-wire type electret mic
Dynamic mic
2-wire type electret mic
Instrument
Bodypack TX3010 Transmitter
1. Power/Mute button: hold for
power, press for mute.
2. CADTone TB4M-type audio input
connector.
3. Transmitting antenna
4. Power indicator
5. High-contrast display
a) Operating frequency
b) RF power indicator
c) transmitter audio gain
indicator
d) mute indicator
e) battery strength indicator
6. IR node for ScanLink
7. SET button. Unlocks advanced
features.
8. UP arrow button. Use to adjust
advanced feature menu items.
9. Battery compartment. Use only
high quality AA alkaline batteries
observing proper polarity.
4
3
1
8
9
2
5
6
7
583.600
a
b
c
d e