CADDX NX-148 Installation Manual - page 9
9
Area 5 Ready
Type code to arm
Service Required
Type
U
2 for help
Control
Over Current
Control
Siren Trouble
Control
Box Tamper
Control
Phone Trouble
Control
Fail to Communicate
Control
Ground Fault
Control
Loss of Time
Control
Power Trouble
Control
Low Battery
Expansion
Aux Comm Fail
Area 5 is selected and Area 5 is ready to arm. To exit the individual partition
mode, enter [#]-[#].
Silencing Alarms in the Multi-Partition Mode
If the keypad is sounding an alarm or the siren is running, it can be silenced by entering a code with the authority for
the area(s) that are in alarm. NOTE: The [EXIT], [BYPASS], and Alarm Memory [
U
]-[3] function keys will only work
if an individual partition is selected.
SERVICE DISPLAY
The following message will be displayed periodically if the security system requires service.
If you see this display, press [
U
]-[2]. One or more of the following fault
messages will be displayed. Use the scroll keys to browse through them.
To exit the service messages, press [#] [#].
A short circuit of a control’s power supply has occurred.
Open circuit has occurred on the bell or siren circuit.
(Optional) The Box Tamper circuit has activated.
The Phone Line connected to the control is not operating properly.
The control attempted to communicate a message to the Central Station,
but was unsuccessful.
A short to ground has been detected on a control circuit.
Your system has lost total power and needs the clock reset.
The main power to your system is not on.
The standby battery is low.
An auxiliary reporting device has failed to communicate.