Cairn 4810 Owner's Manual - page 2
Introduction
cairn
Congratulations, you own a unique device!
This 2-channel integrated amplifier offers all the customisation you need to match
with your system.
You can add a lot of features and benefits, without affect the sound quality; the
Cairn & Ezo staff wish you will spend a pleasant time using
MULTI
SOLUTIONS system for plug & play modules offers advantages without any
compromise.
481O.
CE Declaration of conformity
FCC notice
Cairn declare that this product is in conformance with the Low Voltage Directive 73/23/EEC.
The conformity of the designated product with the provisions of directive number 73/23/EEC (LVD) is proved by full compliance
with the following standards:
Standard EN60065 (1993) test type: Marking, ionizing, heating under normal conditions, shock hazards under normal operating
instructions, insulation requirements, fault conditions, mechanical strength, parts connected to the mains supply, components,
terminal cords, electrical connections and mechanical fixings.
The conformity of the designated product with the provisions of directive number 89/336/EEC (EMC) is proved by full
compliance with the following standards:
Standard number
Date of issue
Test type
EN55013
1994
Conducted emissions
EN55013
1994
Absorbed emissions
EN60555-2
1987
Hamonics
EN60555-3
1987
Voltage fluctuations
EN55020
1994
Immunity
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designated to provide reasonable protection against harmfull interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmfull interference to radio communications. However, there is no garantee
that interference will not occur in a particular installation.
If this equipment does not cause harmful interference to radio or television reception, which can be determinated by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Release 1.04