Cairn 4810 Owner's Manual - page 20
When you make a rotation of the right button, you change the main volume.
For each source (and also for the headphone) you can set up a relative volume
based on the main volume.
You can set it from -6dB to +6dB different from the main volume.
Finally this serves to equalize the volumes of all source to be at same level at output of
If an overload is detected (too much current output to your speakers) the level will be
automatically decreased by steps of 0.5dB, and a message indicates overload.
Software will be released on www.cairn-ezo.com when available.
1-Disconnect
from mains.
2-link connector “Slave” of
to a free COM port of your computer via a standard
Rs232 cable (9 pins).
3-Run software on your computer, select the right COM port from the list.
4-Click the update button.
5-Connect
to mains, the update starts.
481O
481O
481O
481O
481O
481O
481O
481O
481O
481O
481O
.
allows you to monitor a recording.
Follow these steps:
-Connect the source to record to one of the
inputs.
-Connect your recorder input to the “Tape Out” output of
.
-Connect your recorder output to the “Tape In” input of
.
-In the main screen, select the source to record, and activate the monitor.
-Now you listen the output of your recorder.
is protected against short circuit and overload.
If a short circuit is detected (As a wire between speaker outs)
will mute, open the output relay, and a message will be displayed.. You will have
to remove the short circuit, and power off then on
for the message disappears.
7.1
Special
features
7.1
Special
features
cairn
17
7.1 Volumes
7.2 Monitoring
7.4 Software update
7.3 Short circuit protection