Calculated Industries 4087 User Manual - — 9
U
ser
'
s
G
Uide
— 9
g =
paperless Tape (Tape) — Accesses the
Paperless Tape mode (see paperless Tape
section), which keeps track of your past 30 entries.
Useful for checking strings of numbers.
g S
preference Settings (prefs) — Accesses various
customizable settings, such as dimensional answer
formats (see preference Settings section).
Machinist function Keys
C
cutting Speed — Enters or calculates Cutting
Speed. Unitless entries assumed feet per minute
in U.S. mode; meters per minute in Metric mode.
Calculates Cutting Speed given entered Diameter
and RPM (Spindle Speed). Result is displayed as a
whole number.
g C
radial chip Thinning (rcT) — Enters a Cut
Depth and calculates a Radial Chip Thinning
factor to increase the Feed Rate given Feed Per
Tooth, Tool Diameter and a Cut Depth that is less
than one-half the Tool Diameter. Unitless entries
assumed Inches in U.S. mode; millimeters in
Metric mode.
R
revolutions per Minute — Enters or calculates
RPM (Spindle Speed). Calculates RPM given
entered Diameter and Cutting Speed. Result is
displayed as a whole number.
g R
3-Wire Measurement (3-W Measure) — Enters
or calculates a Three-Wire Measurement. Unitless
entries assumed Inches in U.S. mode; millimeters
in Metric mode. Calculates the minimum and
maximum Three-Wire Measurements and Pitch
Diameters given entered Thread Size and Wire
Size, assuming an External thread type. If a
Three-Wire Measurement value is entered, the
Pitch Diameter calculation is based on this entered
measurement.
(cont’d)