Caliber RDD 885BTI User Manual - Setup
EN - 14
Setup
Setup procedures
1.Enter setup mode
Press the [
SETUP] key on the remote control
or touch the setup icon [
] on the user
interface.
The following menu appears after entering
the setup mode.
The General sub-menu is highlighted by
default.
2.Select one sub-menu
Press the direction keys on the remote control
or Touch on the option to display/select an
option.
3.Select one item
Press the [ ] / [ ] key on the remote
control to select one item and then press the
[ ] key to confirm.
4.Select one value
Press the [ ] / [ ] key on the remote
control to select one suitable value and then
press the [ ] key to confirm.
Note:
All following settings can be done by touching
the option directly.
General
● Tuner Region
The unit provides several radio systems
and you can select a correct radio system
according to your country.
● Source
Choose a source for which you would like
to increase or decrease the relative volume
(LEVEL).
● Level
You can set relative volume level from 0 to 6.
● Clock mode
12Hr: Clock displays 12 hour time using
AM and PM.
24Hr: Clock displays 24 hour time up to
23:59.
● Clock
Clock appears in the top right corner of the
screen during certain operations.
Note:
The AM/PM indication will change as you
continue to adjust the hour past 12.
Language
● Language
Select one language of system menu display.
● Subtitle
Select one subtitle language of DVD disc.
Note:
If the DVD disc does not contain the selected
language, the subtitle will be displayed in
default language.
● Audio
Select one dialogue language of DVD disc.
Note:
If the DVD disc does not contain the selected
language, the dialogues you listening to will
be in default language.
● DVD menu
Select one language of DVD MENU
display.
Note:
If the DVD disc does not contain the selected
language, the DVD MENU will be displayed
in default language.
Misc
● Beep
On: When turned on, an audible beep tone
confirms each function selection.
Off: No beep sounds.
● TsCal
When the touch function is not sensitive
or valid, you should calibrate the touch
screen by this function.
Calibrate the touch screen just following
the screen introductions after entering the
TS CAL mode.
● DRC
Employ the Dynamic Range Control for
better playback for low volumes.