Caliber RDD883BT Operating instructions manual - System Setup
18
announcement on or off.
TA mode: Seek, Alarm
Touch [Seek] or [Alarm] to select traffic
announcement’s active mode.
REG: On, Off
Touch [On] or [Off] to select whether identify
the regional code when tuning.
RDS CT: On, Off
T o u c h [ O n ] o r [ O f f ] t o s e l e c t w h e t h e r
synchronize clock time with the signal source.
BT Setting
Pair: On, Off
T o u c h [ O n ] o r [ O f f ] t o c h o o s e p a i r
automatically on or off.
Auto Connect: On, Off
To uch [On ] or [Off] to ch oose co nne ct
automatically on or off.
Auto Answer: On, Off
T o u c h [ O n ] o r [ O f f ] t o c h o o s e a n s w e r
automatically on or off.
PIN Code: Set
Touch [Set] button to open keypad, then
set the bluetooth password by the number
buttons. Touch
KEY PAD
13800138000
1
2
3
4
5
6
7
8
9
*
0
#
the erase previous
number. Touch
KEY PAD
13800138000
1
2
3
4
5
6
7
8
9
*
0
#
to confirm .The original
password is “1234”.
To reset the password, you should enter
the original password first, then input a new
password, touch
KEY PAD
13800138000
1
2
3
4
5
6
7
8
9
*
0
#
to confirm, input the
password again to confirm.
Other Setting
SWC (Steering Wheel Control)
refer to
TS: Adjust
Touch [Adjust] to calibrate the screen.
When the touch operation is not sensitive or
valid, you should calibrate the touch screen
through “TS Calibrate” function.
System Setup
(continued)
Device Connections
Notes of connection
•
This unit is designed to be used in a
vehicle with a 12-volt battery and negative
grounding. Before installing this unit to a
recreational vehicle, a bus, or a truck, make
sure the battery voltage is appropriate for
this unit to be used, otherwise, install a
transformer by professional to convert the
output voltage to 12V.
•
To avoid short circuit in the electrical
system, ensure that the negative battery
cable is disconnected before installation.
•
To prevent short circuit in the wiring and
damaging to this unit, secure all wirings
with cable clamp or adhesive tape. Route
the wirings in a secured, out of heating
place without touching any moving parts
such as gear shift, handbrake, and seat
rails to prevent the wiring insulation being
melted / worn off.
•
Never pass the yellow power cord through
the installation hole into the engine
compartment and connect to the car
battery. Otherwise, a high possibility of
serious short circuit to the electrical system
may occur.
•
Replacing a new fuse with 15A rating
when the old one is broken, using no
fuse or fuse with improper rating may
cause damage to this unit or even fires.
If a proper fuse is installed and electrical
problems still occur, please contact your
local authorised service agent.
•
DO NOT connect other equipments with
the car battery to avoid battery overheating.
•
P l e a s e m a k e s u r e a l l t h e w i r i n g
connections & the cables of the Speakers
are well-insulated. Otherwise, this unit may
be damaged by short circuit.
•
If there is no ACC available, please
connect ACC lead to the power supply with
a switch.
•
If an external power amplifier is connected,
please don't connect P.CONT lead to the
power lead of the external power amplifier,
otherwise, electric spark or other damage
may result.
•
Never ground the speaker output to
prevent the damage to the built-in power
amplifier.