Caliber RDD883BT Operating instructions manual - Basic Operations
7
Basic Operations
Turn on/off the power
1. Press
button to turn on the unit.
The unit goes back to the last status after
power on.
2.
When on, press
button to turn off the
unit.
Mute
Press to cut the sound.
Note:
• Pressing
again or adjusting volume will
release muting.
• MUTE appears on the TFT during muting.
Adjust the volume
Press VOL +/- to increase or decrease the
volume level.
The adjustable range of volume is 0 to 40.
Playing source selection
Method 1:
Press SRC button on the panel or remote
control to cycle through all the available
sources.
Method 2:
Open the 'SOURCE MENU' by touching SRC
at the top left corner of the TFT or press
MODE button on remote control, and then
touch the option you desired or select the
option by moving the cursor and then confirm.
Note:
• When some devices are not ready, they
cannot be selected.
• You should stop switching when the playing
source you desired has been selected and
wait for some seconds, the unit will auto
enter the playing source mode you have
selected.
When parking brake applied
1.
If 'PRK SW' cable is connected to hand
brake switch, the video display of the TFT
monitor will be controlled by driving status,
system setup and input video sources.
2.
When the car is moving ahead, if the
video disc is played, the screen appears
"WARNING!! Engage Parking Brake to
View Video", and blank screen. The above
warning screen will prevent the driver
watching images. The passengers at the
rear seats can watch normally.
When reverse driving
If the rear view video camera is connected,
the unit automatically switches to CAMERA
source during reverse driving. The unit returns
to the original work mode after the reverse
driving is done.
Steering Wheel Control
Touch the top left of the screen to enter
source menu, touch [
] button to enter the
unit system setup menu, select [Other].
1.
At SWC option, use / button to select a
function, then press and hold a button on
the steering wheel (if your steering wheel
supports this function) until the item on the
screen is lit. Now the function is saved in
the button.
2.
Repeat step 1 to set functions of other
steering wheel buttons.
3. Exit the setting menu and you can operate
the player by the buttons on the steering
wheel.
4.
If you want to change the setting, enter the
SWC setting menu, select a function on
the screen, press and hold a button on the
steering wheel for more than 2 seconds,
then the function is saved into the button
on the steering wheel. At the same time, all
other steering wheel settings are clear, you
must reset them.