Califone PowerPro PA919PS Owner's Manual - Mechanical Notations

20

Non-powered Companion Speaker PA919-SP

The PA919-SP is connected to one of two outputs 

from the PowerPro or Powered Companion 

Speaker via SP-50 Cable with 1/4” phone plugs.

Connecting to the “Speaker Out” jack will divide 

the power between the PowerPro PA919SD or 

PA919PS and PA919-SP. Connecting to the 

“Switched Out” will disconnect the internal 

speakers of the PA919SD and deliver all of the 

power to the PA919-SP.

NOTE: 

There are five (5) LEDs on the front of the 

speaker, however they are disconnected because 

there is no internal amplifier or wireless 

receiver in this passive system.

Telescoping Handle

1/4” Phone Jack Speaker In

Integral Wheels

1

2

3

1

2

3

Mechanical Notations

Telescoping Handle and Wheels

These are only intended for pulling the PowerPro over relatively smooth surfaces. Using the handle to lift or 

carry the unit or pulling up stairs will cause damage not covered by the warranty.

Tripod Mount

A recess is incorporated on the bottom of all PowerPro Speakers for mounting to the TP-50 tripod.