Calypso CB-1000 Manual - page 3
Page 3
1.2 Connecting to the CB-1000
Connect to the CB-1000 through its 3-pin phoenix style serial program port, used in combination
with the CB-1000 Utility Software. Several steps are necessary, however, before you begin
programming the unit with the Java based CB-1000 configuration utility.
1.2.1 Build a Serial Programming Cable
Using the 3-pin connector (included), build a serial cable with the 3-pin connector at one end
and a standard 9-pin RS-232 connector at the other end, with the following specifications:
Solder wires to pins 2, 3 and 5 of a female, 9-pin RS-232 connector
Connect the wire on pin 2 (Rx) to the removable connector pin 2 (Tx)
Connect the wire on pin 3 (Tx) to the removable connector pin 1 (Rx)
Connect the wire on pin 5 (Gnd) to the removable connector pin 3 (Gnd)
1.2.2 Connecting Power
Attach one end of + and
power wires to a 2-pin removable connector. Attach the other
end of the wires to pins 1 and 2 of a 4-pin removable connector.
Plug the 4-pin power connector into 4-pin block A on the TB-CW.
Plug the 2-pin power connector into the CB-1000 power receptacle
Plug the 12vdc power supply into the TB-CW.
NOTE: When launched the configuration utility tries to auto-connect to the CB-1000, and if
successful the CB-1000 will beep. You can also manually select the com port from the pull
down selection box.
Power
IR
Serial
3-pin Connector
CB-1000 Rear View