Calypso CB-1000 Manual - page 4
Page 4
1.2.3 Connecting IR
Attach IR+ to Pin 1 and IR- to Pin 3 on a 3-pin Phoenix connector at one end and to pins
3 and 4 of the 4-pin Phoenix connector at the other end
Plug the 4-pin connector into TB-CW block A
Plug the 3-pin IR connector into the CB-1000 IR receptacle
1.2.4 Install and Run CB-1000 Software
CB-1000 software is provided on the CD that accompanies the CB-1000 button panel and is
also available for download from the Calypso web site, under the Support tab. The software
is installed as any standard computer with Java installed and which supports the RXTX
native serial Java library. Versions of the RXTX library are provided for Windows and MAC
OS X. After installation:
Insert the CD into your computers drive.
Create a folder on you computer and place the CB-1000 config Zip file into this folder.
Un-Zip the Zip file and copy all of the files into the newly created folder.
Launch the application named CBconfig.exe. The application automatically detects
active serial ports on your computer and initiates communications with the CB-1000. For
this reason, the CB-1000 should be connected with power applied before launching the
config application.
NOTE: If you are using a USB-Serial converter be sure to install the required USB driver onto
your computer. Failure to do so may result in the computer not recognizing the connection.
The CB-1000 will beep to acknowledge communications.
Click on this
Icon to run the
CB-1000 config
utility