Cambridge Audio Azur 340A User Manual - page 11
340A Integrated amplifer
azur integrated amplifier 11
Bass and treble tone controls
These controls allow subtle adjustments to the tonal balance of the
sound. In the central position these controls have no effect. These
controls only modify the sound through your loudspeakers, they do not
affect the signals sent through the Tape Out connections. With a well
produced CD and a good system the tone controls are unnecessary and
can be switched out. If the musical recording is of poor quality and/or
the loudspeakers/surroundings are lacking it may be necessary to
adjust the tone controls to compensate.
Volume
The Volume control increases/decreases the level of the sound from the
outputs of the amplifier. This control affects the level of the Loudspeaker
output and the headphone output. It does not affect the Tape Out
Connections.
It is advisable to turn the Volume control fully anti-clockwise before
switching the amplifier on.
Balance
This control allows you to adjust the relative output levels of the left and
right channels. In the central position the output from each channel is
equal. This control only modifies the sound through your loudspeakers,
it does not affect the signals sent through the Tape Out connections.
Input selection push buttons
Push the appropriate input selection button to select the source
component that you wish to listen to. The signal selected is also fed to
the Tape Out sockets so that it may be recorded. The input should not
be changed whilst recording, although the recorded signal can be
checked using the tape input Tape monitor.
Tape monitor selection button
This control lets you listen to the output signal from a tape recorder or
signal processor connected to the amplifier's Tape monitor sockets.
When Tape monitor is selected, the source component chosen by the
input selection push buttons continues to be routed to the Tape Out
sockets for recording or processing.
Remote control operation/features
This Amplifier is supplied with a system remote control that operates
both this amplifier and the Cambridge Azur CD players. The functions
relevant to the amplifier are as follows:
Mute - Mutes the audio (indicated by the input LED flashing).
Volume +/- - The volume buttons increase and decrease the Volume of
the amplifier output.
Input select - The five input select buttons and the Tape monitor select
button are used to change the input source.
AP171421 azur 340A English.Chinese User’s Manual Contents - print pantone 2768.qxd 17/01/2005 10:00 Page 10