Cambridge Audio Azur 340A User Manual - page 14

14  azur integrated amplifier  

There  is  no  power

Ensure the AC power cord is connected securely

Ensure the plug is fully inserted into the wall socket and is switched on

Check fuse in the mains plug or adaptor

There  is  no  sound

Make sure the unit is switched on

Check that source component is properly connected

Check that 'TAPE MON' is not switched on (unless tape input is required)

Check that your speakers are properly connected

If using Speaker B terminals check they are switched on

If channel LED is flashing turn mute off

There  is  no  sound  on  one  channel

Ensure that balance control is in the correct position

Check speaker connections

Check interconnects

There  is  a  loud  buzz  or  hum

Check turntable or tone arm for ground and connection lead fault

Ensure no interconnects are loose or defective

Ensure that your tape deck/turntable is not too close to the amplifier

Unable  to  make  or  play  tape  recordings

Check that TAPE MON and TAPE OUT have been connected correctly

There  is  weak  bass  or  diffused  stereo  imaging  

Ensure that speakers are not wired out of phase

Protection  LED flashing

Please see section on protection system (page 13)

TROUBLESHOOTING

Power  Output

Max  Power  Consumption

Total  Harmonic  Distortion

Frequency  Response  

(-1

1dB)

S  to  N  Ratio  

(unweighted)

Slew  Rate  

(into  8

Ω

Ω)

Dimensions  

(HxWxD)

mm

inches

Weight  

kg

Lbs

SPECIFICATIONS

340A

40W (into 8

Ω)

50W (into 4

Ω)

345W

1kHz < 0.01%

20kHz < 0.09%

5Hz - 50kHz

92dB

20V/uS

70 x 430 x 310

2.8 x 16.9 x 12.2

6.2

13.6

AP171421 azur 340A English.Chinese User’s Manual Contents - print pantone 2768.qxd  17/01/2005  10:00  Page 13