Cambridge Audio azur 551R V2 User Manual - page 25
551R V2
azur
25
ENGLISHENGLISH
Configuration 6
- 7.1 channel: L, C, R, LFE, Ls, Rs, Lw, Rw
Center
Right (30°)
Left (30°)
Left Wide (60°)
Left Surround (110°)
Right Surround (110°)
Right Wide (60°)
LFE
Configuration 7
- 7.1 channel: L, C, R, LFE, Ls, Rs, Ch, Cs
Center
Right (30°)
Left (30°)
Left Surround (110°)
Center Surround
Right Surround (110°)
LFE
Center Height
For playback the 551R V2 expects you to have an actual physical speaker
setup approximately conforming to one of the layouts as shown below.
For 5.1 setups the situation is simple, the 551R V2 automatically performs
any DTS Speaker Remapping required, mapping any of the 7 incoming
possibilities to this configuration.
For 7.1 there are two alternative speaker setup you might have. These
corresponds to configuration 1 and configuration 5 as above.
7.1
Configuration 1
or Configuration 5
Center
Right (30°)
Left (30°)
Left Surround Rear (150°)
Right Surround Rear (150°)
LFE
5.1
Here you need to tell the 551R V2 which configuration best matches your
speaker setup by selecting the DTS-HD speaker menu and selecting the 1
or 5 option.
azur 551R
Video In. Select
Audio In. Select
Tone/Sub Config.
Speaker Config.
Speaker Distance
Speaker Level
Speaker Xover
Auto Setup
Advanced Setup
OSD Setup
Panorama
Center Width
Dimension
DTS Spkr Remap
DRC
Back: [I/O]
Off < >
0 >
3 < >
1 < >
Auto < >
The 551R V2 can then perform any speaker re-mapping required
automatically, and maps any of the incoming 7 possibilities to whichever
one of the two 7.1 possibilities you have.
Note: This feature by its nature only works for 7.1 DTS HD Master Audio or
DTS HD High Resolution Audio bitstreams.
Also note that where the incoming speaker configuration and your physical
speaker configuration actually match the 551R V2 performs no mapping as
you'd expect.
Dynamic range control
azur 551R
Video In. Select
Audio In. Select
Tone/Sub Config.
Speaker Config.
Speaker Distance
Speaker Level
Speaker Xover
Auto Setup
Advanced Setup
OSD Setup
Panorama
Center Width
Dimension
DTS Spkr Remap
DRC
Back: [I/O]
Off < >
0 >
3 < >
1 < >
Auto < >
This setting controls the dynamic range of Dolby Digital movie soundtracks
by compressing the audio to limit the difference in level between loud and
quiet passages in the movie.
This can be a useful feature when watching movies late at night for instance.
Three settings are possible:
Auto
– Compression is always applied for Dolby Digital and Dolby Digital Plus
soundtracks. The application and amount of compression to Dolby True HD
soundtracks is dictated by the soundtrack itself.
Off
– No Compression (normal full dynamic range playback)
On
– Compression is always applied for all Dolby soundtracks (reduced
dynamic range playback)
HDMI preview
The 551R V2 feature a HDMI preview that can be used to preview connected
HDMI source devices.
When watching a HDMI video and any other HDMI port having video input,
you can press the HDMI Preview button on the remote control and use the
▲ or ▼ buttons then press the Enter button to choose the HDMI port you
wish to watch. You can also use the HDMI Preview button on the front panel
of the unit.
Note:
The greyed out boxes represent HDMI inputs with no active connections.