Cambridge Audio incognito AS10 Installation Manual - page 10
10
Incognito active ceiling speakers
Local Source Input
It is possible to install a piece of source equipment to be used local
to the room that contains the AS10. This might be a games machine
or CD player in the bedroom, for example. There are two ways of
connecting a local source:
INCOGNITO LM10 WALLPLATE
The LM10 wallplate has a line input and and IR output socket for IR
control of the local source via the AH10/VH10.
See dedicated literature for installation instructions.
Local Jumper MUST be set to left and centre pins – see page 11.
AS10 ONBOARD LOCAL INPUT
A local source can be connected directly to the AS10. IR control of
the source can only be done ‘line-of-sight’ in this case as the AS10
does not have an IR output.
Connection to the local input socket on the AS10-A should be via
screened audio cable, terminated at a suitable faceplate.
Local jumper MUST be set to centre and right pins – see page 11.
Preamp Output
A preamp output is provided for optional driving of an auxiliary stereo
amplifier or active subwoofer etc. Connection from the preamp should
be by screened audio cable.
ADVANCED FEATURES
If utilising the preamp output facility you may wish to activate the
Fader function. This will allow you to balance the relative output
levels between the AS10 and the auxiliary component. Move the
Fader jumper switch on the AS10-A to the centre and right pins (see
page 11).
Independent 24 V local power supply
The AS10 is powered directly from the AH10/VH10 via the Cat-5
cable. If your installation has very long cable runs from the
AH10/VH10 to the AS10 (greater than 30 m) the AS10 must be
locally powered instead. This simply involves plugging an Incognito
PS10 power supply into the local power socket on the AS10.
IR Window
Receives signals from remote controls.
Blinks red to indicate signal received.
Status LED
Speaker on: Solid green.
Speaker off: Off.
Speaker in mute: Blinks slowly green.
Adjusting volume or sound: Blinks orange.