Cambro KSC402 Owner's Manual - page 2
FRESH WATER TANKS
WASTE WATER TANKS
4
TOWEL HOLDER
SOAP DISPENSER
Hand Sink Cart Parts
One faucet spout
One towel holder center bar
One soap dispenser
Two waste water tanks (Gray)
Two fresh water tanks (White)
1
2
3
4
5
2
2
L
R
3
1
3
5
Table of Contents
Assembly
1.Parts Checklist.................................................................... 2
2.Assembly Instructions.......................................................... 2
Start Up and Daily Operation
1.Hand Sink Start Up.............................................................. 3
2.Daily Operation and Changing Tanks..................................... 4
3.Connecting Hand Sink to CamKiosk....................................... 4
Troubleshooting Guide
1.Water Heater........................................................................ 5
2.Water Pump......................................................................... 5
Cleaning Instructions
1.Cleaning and Maintenance Instructions................................. 6
2.Proper Hand Washing Procedures........................................... 6
Replacement Parts............................................................. 7
Warranty and Service...........................................Back Cover
2
Assembly Instructions
1. Install faucet spout by carefully
positioning into center port and
then carefully tighten collar nut.
2. When placing towel bar into bracket,
make sure roller bar is in proper posi-
tion. Use L and R markings on roller so
towel roll is feeding from top of roll
towards operator.
3. Make sure drain flex line is positioned
so it can flow to either waste tank
when properly placed in lower
compartment. See Start Up & Daily
Operation for details.