Cambro KSC402 Owner's Manual - page 4
4
Connecting Your Hand Sink Cart to a CamKiosk
Note: you will need one Bridge Connector (CamKiosk accessory
KMC24, sold separately.)
1. With both Hand Sink Cart and CamKiosk positioned the proper distance,
place top bridge so that it engages with handles of both carts.
2. Install clamp pieces so that they fit over underside of handles on either
side and tighten with 4 arm knobs at each slot position.
3. Using
1
⁄
4
" thumb screws, place strap brackets on either side of open space
between carts, look for threaded insert at front corner of each cart, along
bottom edge.
See your water heater manual for
adjusting water temperature.
Daily Operation
1. Fill both fresh water tanks.
2. Place one set of tanks (fresh and
waste) into sink cart and connect drain
and pump lines as stated in Start Up.
3. Push to the back of the sink
cart cabinet.
4. Place second set of tanks in front area
for later use and close doors.
Changing Tanks
1. To change to second tank supply,
remove front fresh water tank.
2. Switch drain line nozzle to front
waste tank (B).
3. Switch pump line from empty water
tank to second full tank and place
back into its position in front.
4. Briefly turn on faucet to check that
pump is moving water through system.
If so, close doors. You're ready with 5
gallons more.
Connector
Fresh
Fresh
Fill spout
with cap
A
B
Waste
Waste
Cap filler spout
B
A
Side View
To reduce the risk of electric shock, disconnect from power
supply before replacing temperature-limiting device.
Do not plug in electrical power supply to water heater until
tank has been completely filled with water. The heating
elements will burn out if not immersed in water.
Unplug electrical power supply before draining water heater
or removing cover.
Water temperature over
125˚F can cause severe
burns instantly or death
from scalds. Children,
disabled and elderly are at
highest risk of being scalded.
See instruction manual before
setting temperature on water heater.
Check water before washing.
Temperature limiting valves are available
through manufacturer.
The internal parts of this tank have been constructed and
tested by the manufacturer to withstand 400˚F temperature.
To cold
side of
faucet
Cold water
inlet
Hot water outlet
Heat control
on-off switch
Outside
power
connection
cord
Pressure relief
valve & discharge
line to drain
110V switch &
outlet box with
GFI
Water pump
Inlet tube to
fresh water
tank
To hot side
of faucet
Warning label
On/off
switch
Arrester
4. Position front panel on strap brackets and install
1
⁄
4
" thumb screws into
inserts on bottom edge of panel (leave loose).
5. Going under top bridge, install
1
⁄
4
" X 2
1
⁄
2
" long 3 lobe knobs through
slots in top of front panel and tighten against top bridge’s
front section.
6. Once front panel is properly positioned, tighten bottom
1
⁄
4
" thumb
screws either side along bottom edge of panel and both cart bodies.
Side View
Daily Operation