Cambro KSC402 Owner's Manual - page 3
Start Up
First Time Use of Hand Sink Cart
1. Fill one of the fresh water tanks with tap water, reconnect pump
line to water tank connector, and loosen cap for ventilation.
2. Check that drain nozzle is in the waste tank spout. Leave cap to
hang by tether line.
3. Plug in electric cord to a convenient 110V outlet.
(Use 220V outside of U.S.). CEE 7 Type Euro Plug (Must use a
grounded 3 wire type cord.)
4. Open hot side valve on faucet about one quarter turn. Turn switch on
electric box to start pump. With water heater turned
off, allow pump to fill water heater until water begins to run
out faucet spout, then shut valve.
5. Do the same for the cold side of faucet. This will bleed off
air in water lines.
6. Turn on switch on side of water heater, (switch will light up)
and allow time for heater to begin heating water inside tank.
Allow approximately ten (10) minutes.
7. Place second set of tanks in front area pushing first set to the
back of cart. Close door.
8. You are now ready to use the Hand Sink Cart.
Fresh Water Tank
Waste Water Tank
Fresh Water Tank
Waste Water Tank
Waste Tank Spout
Tether Line
Pump
Quick Disconnect
Fitting
3
Pump
Inlet side to fresh
water tank connector
Main switch to turn on
pump and water heater
Out
In
Heat element switch on/off
Fresh Water Tank
Waste Water Tank