Camco 43421 Installation Instructions Manual
1. Using enclosed Overhang Measurement Tool, measure counter
overhang in center of location where you plan to mount extension. Place
overhang tool under overhang with dimension lines facing upward. Slide
tool forward under overhang until it touches cabinet side (Figure A). Note
which line the edge of overhang comes closest to. You may have to round
off, depending on your unit. Record corresponding letter for this dimension
line (for example: If overhang measures 7/8", record letter "C").
If you choose to use a ruler, measure and record the counter overhang.
Section A - Countertops with Overhang
A
Preparation:
• Youwillneedanassistantforthisinstallation.
• Takeyourtimeandbeveryexactfollowingproceduresintheseinstructions.
Papertemplatesaresuppliedtomakethisprocesseasier,butyoumaywanttoactuallymeasuredistanceswitharulerinstead.
• Thisextensionworksoncountertopswithorwithoutanoverhang.UseSECTIONAforcountertopswith
overhang.UseSECTIONBforcountertopswithoutoverhang.
Tools required: Materials included:
SECTION A:Countertopswithoverhang SECTION B:Countertopswithoutoverhang
A countertop overhang of at least 5/8" is suggested for installation according to Section A instructions.
NOTE: Duetovariationsincountertopthickness,countertopextensionmaynotbeflushwithcountertop.
OvErhANg
Cabinet
Cabinet
Countertop Extension Installation Instructions
IMPORTANT: READ CAREFULLY!
C
2.haveassistantholdextensionflushtocounteredge
in fully extended position, level with inside of overhang
(Figure B).Duetovariationsincountertopthickness,
countertop extension may not be flush with countertop.
Thereshouldbenogapbetweenextensionandcounter.
Markpilotholelocationsthroughpianohingeonthe
underside
(Figure C) of overhang and drill holes using
3/32" drill bit.
1
• ruler
• electricdrillwith3/32"drillbit
• Phillipsscrewdriver
(cordless power screwdriver suggested)
• Carpenter’ssquare(recommended)
• Installationinstructions
• (1)OverhangMeasurementTooland(2)Templates
• 10Screws(5/8")
• 12"hinge–attachedtoextension
• Supportbracket
B
Place masking tape on drill bit to mark 3/8" depth as a
guide so you do not drill through the countertop overhang.
Install extension with screws.