Camec Elite Pro2 EM305 User Manual - page 6
CAMEC ELITE PRO
®
2
EM305
Ref: ELITE PRO 2 EM305-0715Rev.A.
6
FOR PROFESSIONAL INSTALLATION ONLY. These instructions are for general guidance.
Installation procedures may vary depending on caravan type.
Working under a vehicle without appropriate support is extremely dangerous!
• Place the caravan on a hard, level surface. The
use of a lifting ramp or an assembly pit is ideal for
access and personal safety.
• Unpack all the components and check for the
presence of all parts (see package contents list
pg. 2). Write down, on the product warranty
registration card, the 10-digit serial number (this
is located on an aluminium plate on the side of
one of the motor units).
• Clean the area of your chassis where you need to
mountallcomponentstoensureagoodfitting.
• Make sure the caravan is prepared for
installation. Check before installation that
important areas, such as drains/spare tyre, etc.
do not cause any obstruction to the function of the
caravan manoeuvring system.
• Ensure both rollers are in the DISENGAGED
position(Fig.5),astheunitwillnotfit
correctly otherwise (Note: when fully disengaged,
the pointer is positioned in the beginning of the
yellow area).
• Loosely assemble the left hand motor unit (1), right hand motor unit (2) and main cross bar (3) (Fig. 4). The nuts
(Fig.4A),onthecrossbar(3)tosecurebothmotorunits,mustbenomorethanfinger-tightatthisstage.
Note:Inprinciple,theunitshouldbefittedinfrontofthecaravanroadwheels,butiffittinginthispositionisnot
possiblebecauseofobstaclesoratoohighhitchballweight,itispermissibletofitittotherearofthewheelsby
rotating the whole assembly (Fig. 4) by 180° degrees.
INSTALLATION - MECHANICAL COMPONENTS
Please refer to Fig. 3 for an overview of the whole assembly fully fitted.
• Fit the Chassis Clamp Plates (34) to the chassis using bolts (35),nuts (36), washers (37) and spring washers (38),
thenlooselyfitthetwoaluminumclampplates(7)totheplates(34)(Fig.3&6)andattach.UsetheboltsM10x60,
nuts M10 and washers M10 (8,17,18) and put them in the diagonal positioned holes of the aluminium chassis
clampplates.Nutsmustbenomorethanfinger-tight.
• Assemble the pre-mounted manoeuvring system on the aluminium chassis clamp plates by using the two
U-shaped brackets (9), bolts M10x50, nuts M10 and washers M10 (16,17,18). Nuts must be no more than
finger-tight.
• Make sure that aluminium drive rollers of the motors are approximately on the same altitude as the centre (axle)
of the caravan wheel (0mm~40mm, see Fig. 5). As well make sure that between the top of the motor housing
andthefloorofthecaravanisminimal20mmspacetomakesurethemotorscanmovefreely(seeFig.3&5).
To compensate a possible unevenness (and lower the motors),
Camec Elite Pro
®
2 has a set of distance plates
available. One set can compensate 15mm. In total three sets can be used so that an altitude of 45mm can be
compensated.