Camec Elite Pro2 EM305 User Manual - page 8
CAMEC ELITE PRO
®
2
EM305
Ref: ELITE PRO 2 EM305-0715Rev.A.
8
INSTALLATION - ELECTRICAL/ELECTRONIC COMPONENTS
Make sure the 12V supply from the battery and any 240V electricity supply are disconnected.
• Remove battery cable terminals and disconnect any external electrical power before starting work.
• Find a suitable place for the electronic control unit (4), such as a storage area, under a seat or a bed. Make sure
this place is dry and close to the battery (40cm to 60cm). The electronic control unit can be mounted vertically
onasidewallorbemountedflat.Whenmountedvertically,theconnectionsmustpointdownwardstoavoidany
short-circuits by objects falling into it.
• Fix the electronic control unit securely into position with two screws M5x40 (33).
Note: if the provided screws are
not of suitable length or type for the desired location/material please substitute these as appropriate.
• Drilla25mmholethroughthefloorofthecaravanapproximately150mmcentrallyinfrontofthecontrolunit(4)
terminals.
Caution! Take extra care to avoid any chassis members, gas pipes and electrical wires!
• Route and connect the motor-cables in accordance with wiring diagram (Fig. 8) (red = positive, black = negative).
The wiring diagram (Fig. 8 + Table. A) below depicts the wiring route when installing the motor units in front of the
wheels/axle towards the ‘A’ frame.
Table A
Table B
FRONT OF AXLE FITTING
REAR OF AXLE FITTING
(4,6mm2 cables)
(4,6mm2 cables)
Motor unit A Positive (+) cable to terminal 4
Motor A Positive (+) cable to terminal 1
Motor unit A Negative (-) cable to terminal 3
Motor A Negative (-) cable to terminal 2
Motor unit B Positive (+) cable to terminal 2
Motor B Positive (+) cable to terminal 3
Motor unit B Negative (-) cable to terminal 1
Motor B Negative (-) cable to terminal 4
Automatic engaging system (1,5mm2 cables):
Automatic engaging system (1,5mm2 cables):
Motor unit A: Positive (+) cable to terminal d
Motor unit A: Positive (+) cable to terminal b
Motor unit A: Negative (-) cable to terminal c
Motor unit A: Negative (-) cable to terminal a
Motor unit B: Positive (+) cable to terminal b
Motor unit B: Positive (+) cable to terminal d
Motor unit B: Negative (-) cable to terminal a
Motor unit B: Negative (-) cable to terminal c
Please refer to Table B (below) for
fitmentofthemotorunitstotherearof
the axle.