Camos CM-709M2 Instruction Manual - page 8
5
PICTURE SETUP
DIMMER AUTO
CONTRAST 50
BRIGHTNESS 50
COLOR 50
TINT 50
LANGUAGE ENGLISH
VIDEO SYSTEM NTSC
RESET >
PICTURE SETUP
DIMMER AUTO
CONTRAST 50
BRIGHTNESS 50
COLOR 50
TINT 50
LANGUAGE ENGLISH
VIDEO SYSTEM NTSC
RESET >
AV MODE DOWN/UP MENU POWER
AV MODE DOWN/UP MENU POWER
14
15
5) When there is an input signal of more than 2 triggers, the monitor displays fully
connected screen (Trigger input screen) as the priority order. And the screen
switsches back when the signal switsches off, the rest will be displayed as the
priority order.
CAM1
CAM4
CAM2
AUX
CAM1
CAM1
AUX
CAM1
CAM3
CAM1
CAM2
CAM4
CAM3
Former screen
Former screen
Former screen
CAM 3 signal output
※ If the screen turns to trigger signal, only volume, mute and audio out choice
available.
※ If there is trigger signal input while power off (Stand-by) status, the screen
switsches on and displays choosen trigger line (camera). And the screens turns
off when the trigger signal switsches off.
CAM 2,3,4 simultaneous
signal input
※ TRIGGER PRIORITY ORDER
CAM3 > CAM1+CAM2 > CAM1 > CAM2 > CAM4
NOTICE
CAM 1,4 simultaneous
signal input
CAM 1,2 simultaneous
signal input
CAM 4 signal output
CAM 2 signal output
Video Standard System, NTSC/PAL conversion
1
If use PAL system on NTSC system using country, it may cause a malfunction. This
products can convert NTSC/PAL system manually but it is not automatic. Before use,
please check and set the system.
7” 4CHANNEL DIGITAL MONITOR
SETTINGS
Dimmer sensor setting
2
※ User can choose DAY/NIGHT/AUTO and it is set AUTO from the factory.
1) Press SETUP button of remote control
(or MENU button of monitor) to go into
OSD MENU [PICTURE SETUP].
2) Move to DIMMER by pressing ▼button
of remote control (or MODE button
of monitor) then choose by pressing
◀▶button (or DOWN/UP button of
monitor)
1) Press SETUP button of remote control
(or MENU button of monitor) to go into
OSD MENU [PICTURE SETUP].
2) Move to VIDEO SYSTEM by pressing
▼ button of remote control (or MODE
button of monitor) then choose video
standard system by pressing ◀▶button
(or DOWN/UP button of monitor)
Attention
NTSC system country : USA, CANADA, JAPAN, KOREA, TAIWAN, MEXICO
PAL system country : AUSTRALIA, BELGIUM, CHINA, DENMARK, FINLAND,
GERMAN, U.K, NETHERLAND, ITALY, KUWAIT,
MALAYSIA, NEW ZEALAND, SIGNAPORE, SPAIN,
SWEDEN, TAILAND, NORWAY.