Campbell cs215 Instruction Manual - page 6
CS215 Table of Contents
ii
7.5 Changing the SDI-12 Address Using LoggerNet and a Datalogger ...... 17
7.5.1 CR200(X) Series Datalogger ....................................................... 17
7.5.2 CR800/CR850 Datalogger ........................................................... 18
7.5.3 CR1000 Datalogger...................................................................... 19
7.5.4 Mixed-Array “Edlog” Dataloggers .............................................. 20
7.5.5 Table-Based “Edlog” Dataloggers ............................................... 22
8. Maintenance and Calibration ....................................23
8.1 Sensor Element Replacement................................................................. 24
9. Troubleshooting.........................................................27
10. References................................................................28
Appendices
A. Environmental Performance .................................. A-1
A.1 Tests to Defined Standards ................................................................. A-1
A.2 Exposure to Pollutants ........................................................................ A-1
A.3 Operating Range of RH Element ........................................................ A-1
A.4 Measurement Below 0ºC..................................................................... A-2
Figures
4-1. CS215 and 41303-5A Radiation Shield on a tripod mast ..................... 3
4-2. CS215 and 41303-5A Radiation Shield on a CM200 Series
Crossarm............................................................................................ 3
7-1. Screen capture of SDI-12 Transparent Mode on CRBasic
CR200(X) Series Datalogger using control port C1/SDI12
and changing SDI-12 address from 0 to 1 ....................................... 18
7-2. Screen capture of SDI-12 Transparent Mode on CRBasic
CR800 Datalogger using control port 3 and changing SD1-12
address from 0 to 1 .......................................................................... 19
7-3. Screen capture of SDI-12 Transparent Mode on CRBasic
CR1000 Datalogger using control port 5 and changing SD1-12
address from 3 to 1 .......................................................................... 20
7-4. Screen capture of SDI-12 Transparent Mode on Edlog array-based
datalogger (CR10X) using control port 8 and changing SDI-12
address from 0 to 1 .......................................................................... 21
7-5. Screen capture of SDI-12 Transparent Mode on Edlog table-based
datalogger using control port 8 and changing SDI-12 address
from 0 to 1 ....................................................................................... 23
8-1. Correct fit of sensor element (side view) ............................................ 26
8-2. Incorrect fit of sensor element (side view).......................................... 27
A-1. Normal Operating Conditions of RH Element .................................. A-2
Tables
5-1. Recommended Lead Lengths ................................................................. 7
7-1. Connections to Campbell Scientific Dataloggers ................................. 10
A-1. Environmental Tests .......................................................................... A-1