Campbell Hausfeld CT1001 Operating Instructions Manual - page 4
Operating Instructions
www.chpower.com
4
Installation (Continued)
Improper use of grounding plug
can result in a possible risk of
electrical shock!
Do not use a grounding adapter
with this product!
2 If repair or replacement of cord or plug is necessary, do not
connect grounding wire to either flat blade terminal The wire
with insulation having an external surface that is green (with
or without yellow stripes) is the grounding wire
Never connect green (or green and yellow)
wire to a live terminal.
3 Check with a qualified electrician or serviceman if grounding
instructions are not completely understood, or if in doubt as
to whether product is properly grounded Do not modify plug
provided; if it will not fit outlet, have proper outlet installed
by a qualified electrician
WIRING
1 Local electrical wiring codes differ from area to area Source
wiring, plug and protector must be rated for at least the
amperage and voltage indicated on motor nameplate, and
meet all electrical codes for this minimum
2 Use a slow blow fuse or a circuit breaker
Glossary of Terms / Getting to Know your Compressor
Pressure Switch - AUTO/OFF Switch -
In the AUTO position, the compressor
shuts off automatically when tank
pressure reaches the maximum preset
pressure In the OFF position, the
compressor will not operate This switch
should be in the OFF position when
connecting or disconnecting the power
cord from the electrical outlet or when
changing air tools
Regulator - The regulator controls the
amount of air pressure released at the
hose outlet
Discharge Tube - This tube carries
compressed air from the pump to the
check valve This tube becomes very hot
during use To avoid the risk of severe
burns, never touch the discharge tube
ASME Safety Valve - This valve
automatically releases air if the tank
pressure exceeds the preset maximum
Check Valve - One-way valve that allows
air to enter the tank, but prevents air
in the tank from flowing back into the
compressor pump
Tank Drain - This valve is located on
the bottom of the tank Use this valve
to drain moisture from the tank daily to
reduce the risk of corrosion
Reduce tank pressure below 10 psi by
pulling the safety valve, then drain
moisture from tank Drain daily to avoid
tank corrosion
Figure 2
Pump
Shroud
Tank
Pressure
Switch
Safety
Valve
Tank Pressure
Gauge
Outlet Pressure
Gauge
Universal
Coupler
Tank
Drain
Regulator