Campbell Hausfeld PS230B Operating And Assembly Instructions Manual - Airless Paint Sprayers
10
Cleanup
ClEANUP FOr OvErNIGhT STOrAGE
NOTE: Cleaning and maintenance
of the pump are the most important
steps you can take to ensure proper
operation and a long life for your
airless paint sprayer. Please follow the
cleaning instructions carefully and . . .
wEAr All NECESSAry
SAFETy GEAr
NECESSAry TOOlS / mATErIAlS:
• One (1) bucket
• Water
• Plastic wrap
whenreusingthe
sprayerwiththe
SAMEpAiNTthenextdayattheSAME
joBSiTE,itisnotnecessarytoflush
thepaintfromthesystem.However,
iTiSiMpoRTANTToKEEpAiRfRoM
coMiNgiNTocoNTAcTwiTHTHE
pAiNT.
NOTE: Do NOT disconnect any hoses.
1. Turn prime/spray control to PRIME
position.
Highpressure
hosemaystillbe
pressurizedwithprime/spraycontrol
inthepRiMEposition.withthegun
pointedinasafedirection,pullthe
guntriggertorelieveanypressurein
thehose.
2. Engage gun trigger lock.
3. Place spray gun in bucket of water.
There should be enough water to
COVER spray tip. This will prevent
paint from drying or clogging tip.
4. Leave suction and bypass tubes in
bucket of paint. Make sure ends
of suction and bypass tubes are
BELOW surface of paint in bucket.
5. Cover bucket and tubes with plastic
wrap or a damp towel to prevent
film forming on paint. Or, if using
latex paint, pour a very thin layer of
water over top of paint. Stir water
into paint the next morning.
Airless Paint Sprayers
Operating Instructions and Assembly Instructions
Turn Prime/Spray
Control to PRIME
Position
1
Place Gun in
Water
Latex Paint: Use Thin Layer of
Water to Cover Paint
www.chpower.com
5
Engage Trigger Lock
Cover Bucket
2
Suction and Bypass Tubes
Remain in Bucket with Ends
Below Paint Surface
4
or
PAINT
PAINT
10
Temporary Cleanup
To Lock
Locked
Water