Campbell Hausfeld PS230B Operating And Assembly Instructions Manual - Airless Paint Sprayers
4
Operating Instructions and Assembly Instructions
Airless Paint Sprayers
SkIN INjECTION hAzArD:
●
High pressure spray can inject toxins
into blood stream. If injection
occurs, seek emergency medical
treatment.
useafacemask/respirator
andprotectiveclothing
whenspraying.Always
sprayinawellventilatedareato
preventhealthandfirehazards.Refer
toMaterialSafetyDataSheets(MSDS)
ofspraymaterialfordetails.
●
Never try to stop leaks with any
part of your body.
●
This system is capable of producing
3000 psi (20 500 kPa). Use only
Campbell Hausfeld replacement
parts rated at 3000 psi (20 500 kPa)
or higher.
Toreducetheriskof
skininjection:
●
Do not aim the
gun at, or spray,
any person or
animal.
●
Keep hands and other body parts
away from the discharge. For
example, do not try to stop leaks
with any part of the body.
●
Do not clean spray tip while it is
attached to the spray gun. Remove
spray tip from gun to clean tip
guard.
●
Always use the nozzle tip guard. Do
not spray without nozzle tip guard
in place.
●
Do not remove tip while cleaning
the pump.
●
Only use a nozzle tip specified by
the manufacturer.
●
Use caution when cleaning and
changing nozzle tips. Before
www.chpower.com
removing the nozzle tip, follow
the manufacturer’s instructions for
turning off the unit and relieving
the pressure.
●
Do not leave the unit energized or
under pressure while unattended.
When not in use turn off the
unit and relieve the pressure in
accordance with the manufacturer’s
instructions.
●
High pressure spray is able to inject
toxins into the body and cause
serious bodily injury. In the event
that injection occurs, seek medical
attention immediately.
●
Check parts for signs of damage.
Replace any damaged parts.
●
This spray gun is rated for 3000 psi
(20 500 kPa). Do not use on systems
designed to produce more than
3000 psi (20 500 kPa).
●
Always engage the trigger lock
when not spraying. Verify the
trigger lock is functioning properly.
• To lock (engage): rotate tabs on
lock to horizontal position.
• To unlock (disengage) to spray:
rotate tabs on lock to vertical
position.
NOTE: If gun sprays while in the locked
position follow instructions in Spray
Gun Maintenance section for trigger
lock.
●
Verify that all connections are
secure before operating. Do not
use pliers to tighten or loosen high
pressure connections.
●
Know how to stop your unit
and bleed pressure quickly. Be
thoroughly familiar with the
controls.
●
Motor is equipped with an
automatic thermal overload. Motor
will restart without warning, after
cooling.
Neveraimor
sprayatyourself
oranyoneelseorseriousinjurycould
occur.
LOCKED
TO UNLOCK
UNLOCKED
TO LOCK