Campbell Hausfeld PW4035 Quick Start Manual

THIS QUICK START GUIDE IS NOT A SUBSTITUTE FOR YOUR OWNER’S MANUAL.  PLEASE REFER TO YOUR OWNER’S MANUAL FOR COMPLETE

DETAILS ON THE SAFE ASSEMBLY AND OPERATION OF YOUR PRESSURE WASHER.

IN460700AV  4/02

Pressure Washers

Quick Start

Guide

Assembly 

1. Slide the handle assembly over the lower legs of the cart

base. Use the standard nut and bolt to secure the right

rear leg. See Figure 1.

2. An eyelet bolt is included with some models to secure the

engine pull cord. Use this bolt and nut to secure the left

rear leg. Be sure to pull the starter cord through before

tightening the bolt. See Figure 2.

3. Attach high pressure hose to gun using adjustable wrench.

Be careful not to overtighten. See Figure 3.

4. Attach spray lance to gun. See Figure 4.

5. Connect high pressure hose to the outlet connection on

pump.  Hand tighten the knob. See Figure 5.

6. Attach clear, plastic chemical

suction tube to chemical

injector hose barb on the

pump. See Figure 6.

7. Secure garden hose (not

included) to the inlet

connection on pump. See

Figure 7.

FOR PW2458 ONLY

Attach front guard to cart base.  Attach detergent basket to

front guard by snapping basket onto the guard and then

bolting down the basket. See Figures 8a and b.

For parts, manuals, product & service information

visit www.chpower.com

© 2002 Campbell Hausfeld/Scott Fetzer

Figure 1 – Assemble Handle

Figure 2 – Secure engine pull

cord

Figure 3 – Attach hose to gun

Figure 4 – Attach lance to gun

Figure 5 – Connect high pressure

hose to pump

Figure 6 – Attach suction tube

to barb fitting

Figure 8a – Snap basket onto guard

Figure 7 – Secure garden hose

Unpacking

• Pressure Washer (pump, engine, cart base)

• Owner’s Manual & Parts Pack (includes nuts, bolts, and

chemical suction tube)

• Handle Assembly

• Spray Gun

• Spray Lance 

• Quick Connect Spray Tips (not included with all models)

• High Pressure Hose

• Detergent Basket (not included with all models)

• Front Engine Guard (not included with all models)

NOTE: If any parts are missing, DO NOT RETURN THE UNIT TO

THE RETAILER. To receive replacement parts, call 

1-800-330-0712. Have the model number of your pressure

washer ready (located on serial number tag).

Figure 8b – Bolt basket to guard