Can-Am Renegade 500 Operator's Manual - page 107
ENGINE
Air Filter
Removal
CAUTION: Never remove or mod-
ify any component in the air filter
housing. Otherwise, engine perfor-
mance degradation or damage can
occur. The engine is calibrated to
operate specifically with these com-
ponents.
Remove seat and central panel.
Release clamps and remove air filter
box cover.
vmo2006-007-027_a
1. Release clamps
Loosen clamp and remove air filter.
vmo2006-007-028_a
1. Clamp
2. Air filter
Cleaning
Pour cleaning solution (P/N 219 700
341) or an equivalent into a bucket.
Put the filter in to soak.
While filter soaks, clean inside the air
filter housing.
Rinse the filter with warm water until
all cleaning solution disappears.
Then, let the filter dry completely.
Installation
Properly reinstall removed parts in the
reverse order of their removal.
Oil Change and Oil Filter
Replacement
Oil and filter are to be replaced at
the same time. Oil change should be
done with a warm engine.
WARNING
The engine oil can be very hot. In
order to avoid potential burns, do
not remove the engine drain plug
or the filter cover if the engine is
hot. Wait until engine oil is warm.
Ensure vehicle is on a level surface.
Remove dipstick.
Clean the oil drain plug area.
Place a drain pan under the oil drain
plug area.
Unscrew oil drain plug.
_____________________
105