Summary of CDI 2012
Page 1
User instructions en cdi 2012 dishwasher.
Page 2: Fig. A
3 contents safety advice setting up, installation water softener unit adjusting the upper basket loading the dishes information for test laboratories half load washing loading the detergent and rinse aid cleaning the filters some practical hints routine cleaning and maintenance description of the co...
Page 3
Fuses and plugs this appliance should be used only on a socket with a minimum rating of 13 amp. Our ready-fitted plug is already equipped with a 13 amp fuse which is bs 1362 asta approved. Any replacement should be exactly the same. If the fuse cover is lost, do not use the plug until it is replaced...
Page 4
7 connecting the outlet hose ■ the outlet hose should disharge into a standpipe, making sure that there are no kinks (fig. 4). ■ the standpipe must be at least 40 cm above floor level and it must have an internal diameter of at least 4 cm. ■ it is advisable to fit an anti-odour air trap (fig. 4x). ■...
Page 5
Loading the salt ■ on the bottom of the machine there is a container for the salt for regenerating the softener. ■ it is important to use only a salt that is specifically designed for dishwasher. Other types of salt contain small quantities of insoluble particles which over a long period of time may...
Page 6
11 loading dishes using the upper basket ■ the upper basket is provided with mobi- le racks hooked to the sides of the basket which can be regulated in two positions: upright and lowered. In the lowered position the racks may be used for tea and coffee cups, kitchen knives and ladles. Glasses with s...
Page 7
Lower basket (fig. 6) m = 8 + 4 soup plates n = 11 + 1 dinner plates o = 12 dessert plates p = serving dish q = cutlery 13 upper basket (fig. 5) a = 5 + 5 + 2 glasses b = 12 saucers c = 4 + 4 + 4 cups d = small bowl e = medium bowl f = large bowl g = 1 + 1 forks h = 1 + 1 serving spoons i = 3 + 3 + ...
Page 8
Loading the detergent and the rinse aid filling the detergent container important it is essential to use a detergent that is specifically designed for dishwashers either in powder, liquid or tablet form. “finish” gives very good results and can be easily obtained. Unsuitable detergents (like those f...
Page 9
17 1 2 3 cleaning the filters the filter system (fig.A “4”) consists of: a central container that traps the larger particles; a flat gauze that continuously filters the wash water; a micro filter, located beneath the gauze, that traps the tiniest particles ensuring a perfect rinse. ■ to achieve exce...
Page 10
19 when cycle is finished after every wash it is essential to turn off water supply and to switch off the machine by pressing the on/off button to the off position. If the machine is not going to be used for some time, it is advisable to follow these rules: 1. Do an empty wash with detergent in orde...
Page 11
20 en 50242 place load capacity with pans and dishes water supply pressure fuse power input supply voltage 12 8 persons min. 0,08 - max 0,8 mpa (see rating plate) (see rating plate) (see rating plate) description of the control technical data: dimensions: height depth width depth with door open cm c...
Page 12
22 ■ close the door to allow the water to be discharged. The running program will be cancelled and the led for the “recommended” program or the led for the program that was used at least 3 times consecutively will start to blink. Important to cancel the "cold rinse" program, simultaneously hold down...
Page 13
25 24 5 • •• • • • • • • • • • • • • 50°c 32 •• •• 65°c 95 •• yes 75°c 120 •• •• • • • • 45°c 140 •• • •• yes •• •• •• • yes yes yes yes programme programme selection yes check list avarage duration in minutes special function buttons available detergent for soaking (prewash) detergent for washing c...
Page 14
27 n.B.: should any of the situations occur and should the machine give a bad wash performance, it is necessary to remove the deposits from the dishes by hand since the final drying cycle hardens the deposits which a second wash in the machine would not be able to remove. If the malfunction continue...
Page 16
The manufacturer declines all responsibility in the event of any printing mistakes in this booklet. The manufacturer also reserves the right to make appropriate modifications to its products without changing the essential characteristics..
Page 17
04.07- 4101291 1 - printed in italy - imprimé en italie en.