Cannon IntelliTroll Owner's Manual - On / Off of Probe
14
SYSTEM OPERATION
On / Off of Probe
There is no on / off switch for the IntelliTroll Probe. The probe automatically turns on when
placed in the water. The probe will automatically turn off when 2 conditions exist: The probe
is removed from the water and the speed wheel stops spinning for 60 seconds.
Once the Probe is placed in the water and the display is turned on data will become visible
on the monitor.
MONITOR OPERATION
The best way to get familiar with your IntelliTroll Monitor is to power-up in simulator mode and
start pressing buttons. You won’t hurt anything by doing so. Your IntelliTroll Monitor will not
save the changes made to the settings while in the simulator mode
Power on and off, simulator mode
POWER ON - press and release the POWER-MENU button.
The fi rst screen will be a menu that allows you to select the mode of operation. You can
choose between simulator and start-up. Simulation will show data on the screen and allows
you the opportunity to view the menus without having to attach the monitor and probe to a
downrigger.
Note: IntelliTroll remembers your previous settings every time you power it on again (this
does not happen in simulator mode).
Selecting the startup option will put the monitor in run mode and data will not be display until
the probe has been activated.
POWER OFF - press and hold the POWER-MENU button until power down window is
displayed.
Set and adjust features
After power-up, features can be adjusted using this button sequence:
Press
the
POWER-MENU button to display the fi rst setup feature.
Press
the
POWER-MENU button to continue scrolling through the features.
Press
the
W and X buttons to change the feature setting.
When you have completed making the changes do not press any buttons for 3 seconds
and the display will revert back to normal run mode and your changes will be saved.