Canon DU7-1178-000 Service manual - page 91
Chapter 4
4-14
From iR C3200 onward, including this model, NTLM authentication (NTLM 0.12) is supported.
In SMB transmission, in place of plain text authentication, NTLM encoded authentication is supported.
This means that by specifying the user name as "domain name\user name" in file transmission, the trans-
mission can be carried out with the user privileges of the specified domain. Also, transmission can be
made to access mode common folders at user level in Win9x OS.
Note: With this function, NAS (Network Attached Stage) and Linux SAMBA folders can now be trans-
mitted. However, this is not guaranteed for all environments, so it is essential to check transmission in the
user's operating environment, before delivery.
4.3.5 FTP Transmission errors
0008-4685
T-4-5
Message
Error code Cause
Remedy
No message #022
Address deleted or invalidated
during transmission
reservation.
- Retransmit deleted address.
- Check that a group address is specified as the transfer
destination and that it contains a valid address.
- Check that a group address is specified as the transfer
destination and whether it contains local print or fax box
only.
- Check whether the specified transfer destination address
has been deleted.
Transmission
cancelled
#099/ #995 - Transmission cancelled by
user.
Resend.
HD full
#702
Operation stopped because HD
full (work area).
- Wait a while then retry. Stop broadcast transmission
with other protocols. This sometimes helps to avoid this
problem.
HD full
#703
Operation stopped because HD
full (image area).
- Wait a while then retry. Stop broadcast transmission
with other protocols. This sometimes helps to avoid this
problem.
Address does
not appear in
address list.
#704
- An error occurred when
address information was being
obtained from the address list.
(Address deleted from list after
scanning, etc. )
- Check address list settings. Or, turn unit OFF/ON.
Address table
not available
#706
- Address table being
imported/ exported from RUI.
- Address book usage doubled
up with other transmission
component (Fax, etc.).
- Quit access from RUI.
- Wait a while and then retry
No response #751
- Server has not booted up.
- Network disconnected. (If
connection cannot be made
with transmission destination,
connection is sometimes cut
mid-way.)
- No Tree name entered.
- Reset caused by internal
error. Processing interrupted.
- Check transmission destination and network settings.
- Enter Tree name.
- Transmission jobs whose processing has stopped for
some reason or other are forced to quit by assigning an
internal error code (#751). As a result, after rebooting,
the job is not run.