Canon imageCLASS MF5850dn Starter Manual - page 9
7
2 Set Up the Machine
Connect Power Cord and Turn On the Machine
1
Connect the power cord into the rear socket
on the back side of the machine and the wall
outlet, and press the [I] side of the main power
switch (A) to turn ON.
Do not remove the USB cap that covers the USB port on
back side of the machine and do not connect the USB
cable at this time.
Do not use a USB cable at this time. You will need a USB
cable during the software installation procedure for
USB connection.
If you want to use the optional paper cassette, attach
the Paper Feeder Unit PF-44 to the machine before
turning ON the machine. (For instructions on how to
attach the Paper Feeder Unit PF-44, see “Attach the
Optional Cassette to the Main Unit ,” on p. 6.)
–
–
–
2
When
or
to select the language, and press
[
OK
].
E N G L I S H
D I S P L A Y L A N G U A G E
If you want to change the display language at a later time,
press [Menu]
→ →
, then select the language.
3
When
or
to select the country, and press
[
OK
].
U N I T E D S T A T E S
C O U N T R Y / R E G I O N
Make sure that the country/region is selected correctly.
If not, faxes may not be sent/received properly.
It is possible to change the country/region at a later
time. To change the country/region, press [Menu]
→
→ →
, and then select the country/
region.
–
–
4
The machine enters the standby mode.
T E X T / P H O T O
1 0 0 % L T R
0 1
5
Turn OFF the main power switch on the right
side of the machine, wait for at least 10
seconds, and then turn ON the power to
restart the machine.
The display returns to the standby mode:
The machine may enter the standby mode (Auto Clear function) while you
are setting it up. Make the setting again from the main menu.
The display turned OFF:
The machine may enter the Sleep mode while you are performing setup.
Press [Energy Saver] to turn the display back ON and continue the setup.
displayed:
Check the installation of the toner cartridge and the placement of the paper.
(See “Unpack the Machine,” on p. 3.)
Make sure that the front cover and scanning platform are closed properly.
(See “Unpack the Machine,” on p. 3.)
●
●
●
●