D-Link 2Voice + 4SW VoIP Router DVG-1402S Quick Installation Manual - Hardware Overview
2
Hardware Overview
Front Panel
Power LED
Indicates the unit is powered on.
Status/Alarm
The Status LED will flash when performing a self-test/booting up or
is registering with the service provider. The Status LED will flash
green slowly when the system is connected with the service. The
Alarm LED will light solid red if the self-test or bootup fails. The
Alarm LED will flash red slowly when the system is ready but cannot
receive an acknowledgement from the service.
Prov
This LED flashes when the device has established a connection
and received authorization from your service provider.
WAN LED
When a connection is established the 10 or 100 LED will light up
solid. The LED will blink to indictate activity. If the 10 or 100 LED
does not light up when a cable is connected, verify the cable
connections and make sure your devices are powered on.
LAN LEDs
When a connection is established the 10 or 100 LED will light up
solid on the appropriate port. The LEDs will blink to indictate
activity. If the 10 or 100 LED does not light up when a cable is
connected, verify the cable connections and make sure your
devices are powered on.
Phone LEDs
This LED displays the VoIP status and Hook/Ringing activity on the
phone port that is used to connect your normal telephone(s).
MWI: Lights to indicate a voicemail is waiting.
Hook/Ring: If a phone connected to a phone port is off the hook
or in use, this LED will light solid. When a phone is ringing, the
indicator will blink.