D-Link AirPlus XtremeG Ethernet-to-Wireless Bridge DWL-G810 Quick Installation Manual - Ethernet-Enabled Device
2
Connecting the DWL-G810 to your
Ethernet-enabled device
A.
First, connect the power adapter to the Power Receptor on the rear panel of the
DWL-G810 and then plug the other end of the power adapter to a wall outlet or
power strip. The Power LED will turn ON to indicate proper operation.
B.
Insert one end of an Ethernet cable (included) to the Ethernet port on the back
panel of the DWL-G810 and connect the other end to the Ethernet port located
on the device (e.g., a set-top box, laptop or desktop computer, or network printer.)
The LED light will blink when there is data transfer through the wireless connection.
(Note: The Ethernet port on the DWL-G810 is Auto-MDI/MDI-X. Meaning you
can use a straight-through or crossover-cable to the Ethernet Port.)
C.
The antenna is used by the DWL-G810 to connect to other 802.11b/g wireless devices.
A.
Receptor for
Power Adapter
C.
Antenna
Used to wirelessly connect to
802.11b/g networks.
B.
LAN Port
This is the connection for
Ethernet cables to your
Ethernet-enabled device.