D-Link DAP-3320 Quick Install Manual - Dap-3320 Install Guide
DAP-3320 Install Guide
3
1
Reset Button
Press and hold for six seconds to reset the access point
to the factory default settings. The LED will turn on for
two seconds and then begin the reboot process.
2
Power LED
A solid green light indicates the device is powered
and operational.
3
LAN (PoE) Port
Power is supplied to this port via an Ethernet cable
that is connected to a PoE injector or a PoE switch.
4
Ground
Connect a grounding wire to help prevent device
damage due to shorts and lightning strikes.
• CD-ROM Drive
• Computers with Windows®, Macintosh®, or Linux-based
operating systems with CD-ROM drive
• Installed Ethernet adapter
• Internet Explorer 8, Chrome, Firefox, or Safari 5.1 or higher
Note: To power the unit, use a D-Link PoE switch or the D-Link DPE-301GI PoE injector (not included).
Hardware Overview
1
2
3
4