D-Link DGE-530T Quick Install Manual - Configure Your Adapter
6
7
D-Link DGE-530T Quick Install Guide
Configure your Adapter
Configure your Adapter
After you install your new D-Link adapter, by default, the TCP/IP
settings should be set to obtain an IP address from a DHCP server
(i.e router) automatically. To verify your IP address, please see the
following steps below.
Windows
®
2000/2003/XP: Click on
Start > Run
. In the run box type
cmd
and click
OK
.
Windows
®
7/Vista
®
: Click on
Start > All Programs > Accessories
> Command Prompt
.
At the prompt, type
ipconfig
and press
Enter
.
This will display the IP address, subnet mask, and the default gateway
of your adapter.
If the address is 0.0.0.0, check your adapter installation, security
settings, and the settings on your router. Some firewall software
programs may block a DHCP request on newly installed adapters.