D-Link DGS-1210-10P User Manual - page 63
5 Configuration
D-Link Web Smart Switch User Manual
And the Deny low priority port applied the port priority setting configured from PoE port setting page. Default
setting is Deny next port.
Note: The power management policy is only
effective while PoE system entering guard band
mode (0 < remainder power <= 7).
Time-Based PoE > Time Range Settings
The Time Range window is used in conjunction with the PoE feature to determine the powering time range
based on days of the week when PoE is enabled on the Switch port. Once it is configured here, the time
range settings will be applied to the PoE port setting.
Figure 94 – Time-Based PoE > Time Range Settings
Range Name: Name of a time range profile.
Date: Select the checkbox if there is a certain date range for the profile to use. Select from drop-down menu
of From Day and To Day to define the date range.
Hours: Select from drop-down menu of Start Time and End Time to define the range of a day. Note: If the
End Time is before the Start Time the End date should be set to the following day.
Weekdays: Select the checkboxes for the days you want to apply the time range profile per week. You can
select all days.
Click Apply to confirm profile creation.
LLDP > LLDP Global Settings
LLDP (Link Layer Discovery Protocol) provides IEEE 802.1AB standards-based method for switches to
advertise themselves to neighbor devices, as well as to learn about neighbor LLDP devices. DGS-1210-10P
will keep the information in the Management Information Base (MIB). SNMP utilities can learn the network
topology by obtaining the MIB information in each LLDP device. The LLDP function is enabled by default.
The DGS-1210-10P and DWL-3140AP can be centrally managed and discovered via the optional D-Link
Smart WLAN Manager.
Figure 95 –LLDP > LLDP Global Settings
5
5
7
7