D-Link DGS-1210-10P User Manual - page 9

1  Product Introduction  

D-Link Web Smart Switch User Manual

the switches with other third-party devices for management in an SNMP-enabled environment. D-Link Web 

Smart Switches also come with the D-View plug-in module that works with D-View 6 SNMP Management 

Software, and provides easy-to-use graphic interface and facilitates the operation efficiency. 

DGS-1210-10P 

8-Port 10/100/1000Mbps plus 2 1000Base-T/SFP ports Web Smart PoE Switch 

Front Panel 

SFP ports for optical transceivers

Figure 1 – DGS-1210-10P Front Panel 

Power LED

: The Power LED lights up when the Switch is connected to a power source. 

Pwr Max: The Pwr Max LED lights up when the Switch reaches the maximum power budget defined by the 

administrator via PoE System Settings page of Web GUI or the default power budget of 78 Watts. 

Reset: By pressing the Reset button, the Switch will change back to the default configuration and all 

changes will be lost. 

Mode: By pressing the Mode button, the Port LED will switch between Link/Act and PoE modes. 

Port Link/Act/Speed LED (1-8, 9T, 10T, 9F, 10F): When mode LED lights up in Link/Act mode, the port 

LEDs indicate a network link through the corresponding port. Blinking indicates the Switch is either sending 

or receiving data to the port. When the port LED glows in amber, it indicates the port is running on 10M or 

100M. When the port LED glows in green, it is running on 1000Mbps. 

NOTE: On DGS-1210-10P, the SFP ports are 

shared with normal RJ-45 ports 9 to 10. When 

optical transceiver is inserted to SFP port and 

link up, the RJ-45 port cannot be used.

Port PoE LED (1-8): When mode LED lights up in PoE mode, the port LEDs indicate powering status over 

the corresponding port. 

Rear Panel 

Figure 2 – DGS-1210-10P Rear Panel 

Power: The power port is where to connect the AC power cord. 

3

3