D-Link DGS-1210-10P User Manual - page 67
6 Command Line Interface
D-Link Web Smart Switch User Manual
NOTE: Save your configuration changes before
logging out.
Ping
This command checks if another computer is on the network and listens for connections. You can
ping the switch from any IP workstation the switch is connected to through the managed VLAN
(VLAN 1 by default), as long as there is a physical path between the switch and the workstation. The
terminal interface sends five pings to the target station.
Syntax
ping
Parameter
Parameter
Description
The IP address of the target station.
Reboot
This command reboots the system. All network connections are terminated and the boot code
executes.
Syntax
reboot
Reset
All configurations will be reset to the default settings.
Syntax
reset config
Show ipif
The command displays the current IP address of the switch.
Syntax
show ipif
Example
Figure 100 – The show ipif Command
Show switch
The command displays the status of the switch.
Syntax
show switch
Example
6
6
1
1