D-Link DGS-1510 Series Hardware Installation Manual - page 27
DGS-1510 Series Gigabit Ethernet SmartPro Switch Hardware Installation Guide
27
a. The
Bits per second should be 115200 baud.
b. The
Data bits should be 8.
c. The
Parity should be None.
d. The
Stop bits should be 1.
e. The
Flow control should be None.
Figure 4-1 Hyperterminal Connection Properties
4. Now the Switch can be turned on and access to the Switch’s CLI will be available.
NOTE: Access to the console port can be made at any time while the Switch is on. There
is no need to turn the Switch off when plugging the console cable into the console port.
Connecting to the Switch for the First Time
After successfully connecting to the Switch’s console and the Switch was turned on, the boot-up
procedure will be displayed, as shown below.