D-Link DGS-1510 Series Hardware Installation Manual - page 39
DGS-1510 Series Gigabit Ethernet SmartPro Switch Hardware Installation Guide
39
Light off
Power off.
Console
Green
Solid Light
Console on.
Light off
Console off.
Fan
Green
Solid Light
Diagnostics pass. Normal operation.
Red
Solid Light
Fan failure.
Stacking ID
Green
Capable 1 – 6, H, h,
E, G.
The box ID is assigned either by user
(static mode) or by the system
(automatic mode). When the box
become a primary master, the 7
segment works as bi-function. That is
box ID and “H” indicate as primary
Master and the display will be shown
by turn.
That is boxID -> H -> boxID -> H.
1-6: To indicate the stacking of the
switch.
H: When device was assigned as the
stacking Master.
h: When device was selected to be the
Backup Master.
E: Error was found during system self-
test.
G: When Safeguard Engine entering
the exhausted mode.
Port LED Mode
Indicator
A LED Mode Select Button to switch two modes in turn for all
10/100/1000Mbps ports on DGS-1510-28P:
Link/Act/Speed Mode
PoE Mode (Only DGS-1510-28P)
Green
Solid Light
A LED Mode Select Button to switch
Link/Act/Speed Mode
Solid Light
A LED Mode Select Button to switch
PoE Mode
LED Per
10/100/1000 Mbps
Port
Link/Act/Speed Mode Green
Solid Light
When there is a secure connection (or
link) to 1000Mbps Ethernet device at
any of the ports.
Blinking
When there is reception or
transmission of data occurring at
1000Mbps.
Orange
Solid Light
When there is a secure connection (or
link) to 10/100Mbps Ethernet device at
any of the ports.
Blinking
When there is reception or