D-Link DGS-3024 Manual - Default Vlans

DGS-3024 Gigabit Ethernet Switch Manual

Default VLANs 

The Switch initially configures one VLAN, VID = 1, called "default." The factory default setting assigns all ports on the 

Switch to the "default."   

Packets cannot cross VLANs. If a member of one VLAN wants to connect to another VLAN, the link must be through an 

external router. 

NOTE

: If no VLANs are configured on the Switch, then all packets will be 

forwarded to any destination port. Packets with unknown source addresses 

will be flooded to all ports. Broadcast and multicast packets will also be 

flooded to all ports. 

An example is presented below: 

VLAN Name 

VID 

Switch Ports 

System (default) 

1 

5, 6, 7, 8, 21, 22, 23, 24 

Engineering 

2 

9, 10, 11, 12 

Marketing 

3 

13, 14, 15, 16 

Finance 

4 

17, 18, 19, 20 

Sales 

5 

1, 2, 3, 4 

Table 7- 2.  VLAN Example - Assigned Ports 

VLAN and Trunk Groups 

The members of a trunk group have the same VLAN setting. Any VLAN setting on the members of a trunk group will apply 

to the other member ports. 

NOTE

: In order to use VLAN segmentation in conjunction with port trunk 

groups, you can first set the port trunk group(s), and then you may 

configure VLAN settings. If you wish to change the port trunk grouping with 

VLANs already in place, you will not need to reconfigure the VLAN settings 

after changing the port trunk group settings. VLAN settings will 

automatically change in conjunction with the change of the port trunk group 

settings. 

Static VLAN Entry 

In the Configuration folder, open the VLANs folder and click the Static VLAN Entry link to open the following window: 

55