D-Link DI-1750 Installation Manual - page 16
DI-1750 Router
16
Installing WAN Interface Cards
This section describes how to install WAN interface cards (WICs) and Voice Interface Cards (VICs) in D-Link DI-1750
router. Before performing any of the following procedures, ensure that power supply of the router is put OFF and the power
mains cable is removed from the power mains outlet.
Caution: Do not insert any interface card into the module slot when the router is powered ON or when cable is
connected to the Interface card.
To install an interface card in D-Link DI-1750 router, please follow the steps below:
1. Power OFF the router. To avoid damage due to ESD voltages, channel the router chassis to ground.
2. Remove all network interface cables, including telephone cables, from the rear panel.
3. Use a flat-blade screwdriver to remove the blank filler panel from the slot where you plan to install the card. Save the
filler panel for possible future use.
4. Align the module with the guides in the chassis and slide it gently into the slot.
5. Push the module into place until the edge connector is securely seated in the connector on the motherboard. Ensure
that each of the module’s captive screw lines up with its corresponding hole in the chassis.
6. Secure the captive mounting screws into the holes of the chassis using a flat-blade screwdriver.
7.
Please refer the Interface Card Installation Guide for detailed WAN & VIC Interface installation procedure.
8.
After completing the hardware installation, please refer the Software Configuration Guide to configure the Router
parameters.
Interface Combination Matrix :-
Please refer to the Interface Card Hardware Installation Manual for detailed description of each interface card.
Model
Name
Description
Protocol/Standard
DRW-1T
1 port Serial
1 port Asynchronous/Synchronous
V28/V35 serial interface card.
V.24/V.28; RS232-D
X.21bis;V.35;
RS422/RS449
DRW-2T
2 port Serial
2 port Asynchronous/Synchronous
V28/V35 serial interface card.
V.24/V.28; RS232-D
X.21bis;V.35;
RS422/RS449
DRW-1ETH
1 port Ethernet
1 port 10M Ethernet interface card.
Ethernet 10BaseT
DRW-2ETH
2 port Ethernet
2 port 10M Ethernet interface card.
Ethernet 10BaseT
DRW-1E1T
1 port
Ethernet+1 port
Serial
1 port 10M Ethernet interface plus
1 port Asynchronous/Synchronous
V28/V35 serial interface card.
Ethernet 10BaseT
V.24/V.28; RS232-D
X.21bis;V.35;
RS422/RS449
DRW-8ASY
8 port
Asynchronous
8 port V.28 serial interface card.
V.24/V.28; RS232-D