D-Link DIR-330 - Wireless G VPN Router Quick Install Manual - Connect to Your Network
D-Link DIR-330 Quick Install Guide
Connect to your Network
If you are connecting the router to a cable/DSL/satellite modem,
please follow the steps below:
1. Place the router in an open and central location. Do not plug the
power adapter into the router.
2. Turn the power off on your modem. If there is no on/off switch, then
unplug the modem’s power adapter. Shut down your computer.
3. Unplug the Ethernet cable (that connects your computer to your
modem) from your computer and place it into the Internet port
on the router.
4. Plug an Ethernet cable into one of the four LAN ports on the router.
Plug the other end into the Ethernet port on your computer.
5. Turn on or plug in your modem. Wait for the modem to boot (about
30 seconds).
6. Plug the power adapter to the router and connect to an outlet or
power strip. Wait about 30 seconds for the router to boot.
7. Turn on your computer.
8. Verify the link lights on the router. The power light, Internet light,
and the LAN light (the port that your computer is plugged into)
should be lit. If not, make sure your computer, modem, and router
are powered on and verify the cable connections are correct.